Analog-way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual Bedienungsanleitung PDF herunterladen (Seite 70)

7.3.17 Control management

Details can be seen clicking on the magnifying glass.

Inputs EDID sengs are EDIDs assigned on the inputs. There are default EDIDs, it

can be modied by dropping EDIDs from the Library. Each EDID (one per input type,

for each input) can be reset to factory. There is also a global reset for all inputs.



The Tally-GPIO is a set of inputs/outputs to control the device externally and

have a feedback from the device.

Here is the pin assignment for GPIO:

The pins 1 and 2 are dedicated to turn on and o the device; a switch has to be

placed between these two pins.

It works as the front panel switch: when the device is on, close the switch

will request the device to power down, if the switch is closed more than four

seconds, a forced power down is performed. When the device is o, close the

switch will turn on the device.

Only a wire with a simple switch can be connected.



GPOs are opcally isolated MOSFET, working as mechanical relays.

They all have a common pin (the 5th).

The polarity of GPO1, 2, 3, 4 and 5 have to be congured: normally open or normally closed.

The mode of the GPO can be:

manual mode, the state can be dened by a user acon through the Web RCS or by an automaon

controller)

automacally generated, before or aer a TAKE operaon.

If automacally generated, it can be just before the transion (at the beginning of the transion eect) or

aer (when the eect is nished).

In TALLY mode, one or several inputs have to be chosen for a screen, then when used on this screen, a GPO/

TALLY level change will occur.

1 ON/OFF switch pin1

2 ON/OFF switch pin2

3 GPI negave

4 GPI posive

5 GPO return (common)

6 GPO 1

7 GPO 2

8 GPO 3

9 GPO 4

10 GPO 5

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 117 118

Keine Kommentare

Analog-way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual Bedienungsanleitung Seite 70