Analog-way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual Bedienungsanleitung PDF herunterladen (Seite 13)

4.2 Unpacking and inspecon

• 1 x LiveCore™ unit

• 1 x Power supply cord

• 1 x Ethernet cross cable (for device control)

• 1 x Web-based Remote Control Soware included and hosted on the device

• 1 x Rack mount kit

• 1 x User manual (PDF version)*

• 1 x Quick start guide*

* User manual and Quick start guide are also available on www.analogway.com

Before racking and plugging any inputs and outputs, it is advised to power on the unit. Should you encounter

any issue, you must contact immediately your local distributor or dealer, or closest Analog Way technical

support oces (see chapter: 14. Contact informaon).

 LiveCore™ unit can be used directly on a table; the unit is equipped with 4 handy an-

slip rubber feet.

 LiveCore™ unit is compable with a 19” enclosure. Please follow the instrucons below to

install the device in a 19” rack.

 a 4U LiveCore™ unit weighs 42.77LBS (19,4Kg) and 3U weighs 30.86LBS (14Kg). Please provide

appropriate support to the frame during installaon. First, place ears on each side of the device (ref: 180469)

Place the device in your rack. Aach the device to the rack by using 2 screws through the ears (screws not

included).

Addional support, such as the rear rack support or slide rails, is required. LiveCore™ unit is equipped with

threaded holes designed for compability with a rear rack mount such as ref. 180489. Use the holes in the

rear support arm to adjust the length of the rear rack support arm in order to reach the rear rack rail when

installed in the rack. Use four M4x10mm screws in the countersunk holes in the rear support bar on both

sides of the unit.

A lacing bar is provided with the rack mount kit (ref: 180489). Install it with the M4x10 screws according to

your cables posion.

Connect all of the cables to the device and aach them to the lacing bar with the help of e wraps.



- The openings in the front and rear panels of the device are for cooling. Air ows from front to back. Do not

cover these openings to avoid cung air circulaon.

- The maximum ambient operang temperature should not exceed 40°C (104°F).

- The rack and all mounted equipment in it must be reliably grounded according to naonal and/or local

electrical standards.

4.2 

4.3 

CAUTION!

Mounng using only the front rack ears is sucient for xed installaons. Addional support, such as the rear rack support or

slide rails, is required for mobile applicaons, and recommended for all.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 117 118

Keine Kommentare

Analog-way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual Bedienungsanleitung Seite 13