Analog way Pulse LE Bedienungsanleitung PDF herunterladen (Seite 44)

Once your Pulse LE is wired up to your PC, the rst step in properly

conguring your machine is to individually select and parameter your

inputs.

1/ Click on the “Inputs” tab of the RCS.

2/ In the Plug column of the “Input” page, select the plug type by

clicking the appropriate eld.

3/ Activate the input in the Enabled column if it is not.

4/ In the scroll-down menu of the Type column, select the signal type

connected to that plug.

5/ Repeat steps 2 to 4 for all sources connected to the rear panel of

your Pulse LE.

6/ Click on the “Inputs” tab to return to the main screen.

1/ Click on the “Outputs” tab of the RCS.

2/ Select the type of plug which is connected to outputs 1 & 2 of your

Pulse LE by clicking in the appropriate eld in Analog Type or DVI

Type for both Main and Preview outputs.

3/ Select the appropriate output format and output rate.

4/ Click on the “Outputs” tab to return to the main screen.

The Output menu also allows you to generate test patterns. The

test patterns available through the Output menu let you quickly and

reliably setup your projectors.

* NOTE * : Be sure to turn the test pattern off to display your sources

again.

The Pulse LE with the Frame/PIP option installed, allows users to

manipulate a PIP (Picture In Picture) which you can move, size, crop

or zoom, apply transparency or transitions to.

5-2. WORKING WITH THE RCS

Source input conguration

Source output conguration

Working with PIPs

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 52 53

Keine Kommentare

Analog way Pulse LE Bedienungsanleitung Seite 44