Ref. SMX12x4
Thank you for choosing and the . By following these simple steps, you
will be able to set up and use your Powerful mul-screen Seamless Switcher based on ’s new
LiveCore™ plaorm within minutes. Discover the capabilies and intuive interface while
commanding top-notch presentaons and unleash your creavity for a new experience in show and event
management.
• 1 x
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x MCO 10 pin connector
• 1 x Web-based Remote Control Soware included and hosted on the device
• 1 x Rack mount kit (the parts are stowed in the packaging foam)
• 1 x User manual (PDF version)*
• 1 x Quick start guide*
* User manual and quick start guide are also available on www.analogway.com
The uses standard ethernet
LAN networking. To connect the Web RCS to your
new , you rst need to connect
a computer to the using the
Ethernet cable. Then on your computer open an
internet browser which supports Flash® player.
Into this internet browser, please enter the IP
address of the displaying on the
front panel screen.
The connecon should start.
Oen, computers are set to DHCP client (automac
IP detecon) mode. You may need to change the
IP address conguraon on your computer before
you can connect. These sengs are found in the
properes for your LAN network adaptor, and vary
by operang system.
The default IP address on the
is with a netmask of
Therefore, you can assign your computer a stac
IP address of and a netmask of
and should be able to connect.
If the connecon is not starng, please see:
• Be sure the computer IP address is on the same
network and subnet as the .
• Be sure that no two devices have the same IP
address (prevent IP conicts)
• Check your network cable. You will need a crossover
ethernet cable if you are connecng directly from
the to the computer. If a hub
or switch is involved, use straight ethernet cables.
• For more informaon, please see the user manual
or contact Analog Way Technical Support.
Once you have successfully connected, the ash
app will automacally download and launch in your
browser. When the two icons in the boom right
corner of the screen turn green, the Web RCS is
ready to use. If you are having trouble syncronizing,
try clearing the cache and refreshing the page
(ctrl+F5 in most browsers):
- will turn green when connected
- will turn green when the Web RCS has
nished syncronizing.
The use of rear rack support
slide rails for all rack mounted
applicaons is highly recom-
mended. Damage caused by im-
proper rack mounng will not be
covered under warranty.
Kommentare zu diesen Handbüchern